PerTronix Dougs Headers D3345 - Manual (Page 3)

Part No. 0110-003081
Page 3 of 3
rev 2 8-15-2011 DSL
If dipstick tube was removed, make sure it is installed properly and that the
dipstick has been replaced.
Double-check the tightness of all bolts including brackets and accessories.
To complete your exhaust system
order the correct 2 ½” reducers for your exhaust
pipe size. Cut the stock pipes to the right length and weld to the reducer or fashion
a new system using performance mufflers and 2 ¼” or 2 ½” exhaust pipes.
STARTING THE ENGINE
Start the engine and allow it to warm up to operating temperature. Check for any unusual
noises or exhaust leaks. If every thing is OK, stop the engine and tighten all bolts while
the engine is still warm.
NOTE: Check the bolts periodically to make sure they have not loosened. Re-tighten
after the first 500 miles and then again at 1000 miles.
PARTS LIST
Qty Description
1 Left Side Header
1 Right Side Header
2 Header Gaskets
2 Collector Gaskets
16 3/8-16 X 1 ” Header Bolts
16 Lock-
Washer 3/8”
6 3/8-16 X 1 1/4 ” Collector Hex Head Bolts
6 3/8-16 Hex Nuts
6 3/8” Lock Washers
2 Header Reducers
Illustration A
Cut 5/16” from end
of spark plug shields