PerTronix Dougs Headers D3334 - Manual (Page 3)

Part No. 0110-003084
Page 3 of 3 rev.1 9-6-13 DSL
IMPORTANT CHECK LIST
Be sure that all brake lines and fuel lines are clear of headers and/or connector pipes.
All spark plug wires, battery cables, or other electrical components should be clear of
headers and/or connector pipes.
If dipstick tube was removed, make sure it is installed properly and that the dipstick has
been replaced.
Double-check the tightness of all bolts including brackets and accessories.
STARTING THE ENGINE
Start the engine and allow it to warm up to operating temperature. Check for any unusual
noises or exhaust leaks. If every thing is OK, stop the engine and tighten all bolts while
the engine is still warm.
NOTE: Check the bolts periodically to make sure they have not loosened. Re-tighten
after the first 500 miles and then again at 1000 miles.
PARTS LIST
Qty Description
1 Left Side Header
1 Right Side Header
2 Header Gaskets
12 8mm-1.25 X 25mm, Header Bolts
16 Lock-Washer (8mm)
2 Gasket (A.I.R.)
4 8mm-1.25 X 25mm Hex Head Bolts (for A.I.R.)
2 Angled Reducers (L & R)
2 Stainless Steel Band Clamps