PerTronix JBA Exhaust 40-2636 - Manual (Page 3)

Re-Assembly-
13) Replace mid-section of rear grille.
14) Raise, and secure trans axle cross bolt.
15) Lower JBA muffler into place. Rest on frame rails for now.
16) Thread muffler support brackets into place. Re-assemble, loosely attach to muffler.
17) Using supplied hardware and gaskets, attach cat pipes to muffler assy.
18) Align and secure cat pipes to muffler, cat pipes to manifold, and muffler brackets.
19) Re-install lower grille.
20) Re-install air box.
21) Recheck all installation procedures.
22) Reconnect Neg. battery cable.
23) Start engine to check for leaks, rattles, etc.
24) Re-install lower belly pan.
40-2636.indd 3 3/30/10 4:01:44 PM