PerTronix Flame-Thrower HEI Distributors D1352 User Manual
Hei distributor installation instructions

HEI dIstrIbutor
InstallatIon InstructIons
LIMITED WARRANTY
PerTronix, Inc. warrants to the original Purchaser of its Flame-Thrower billet
distributor that the product shall be free from defects in material and workmanship
(normal wear and tear excluded) for a period of 12 months from the date of
purchase.
If within the period of the foregoing warranty PerTronix finds, after inspection,
that the product or any component thereof is defective, PerTronix will, at its option,
repair such products or component or replace them with identical or similar parts
PROVIDED that within such period Purchaser:
1. Promptly notifies PerTronix, in writing, of such defects.
2. Delivers the defective product or component to
PerTronix (Attn: Warranty) with proof of purchase date; and
3. Has installed and used the product in a normal and proper
manner, consistent with PerTronix printed instructions
THE FOREGOING LIMITED WARRANTY IS EXCLUSIVE AND IN LIEU OF
ALL OTHER WARRANTIES, WHETHER EXPRESS OR IMPLIED, INCLUDING
ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE.
THE FURNISHING OF A REPAIR OR REPLACEMENT COMPONENT
OR COMPONENTS SHALL CONSTITUTE THE SOLE REMEDY OF
PURCHASER AND THE SOLE LIABILITY OF PerTronix WHETHER ON
WARRANTY, CONTRACT OR FOR NEGLIGENCE, AND IN NO EVENT WILL
PerTronix BE LIABLE FOR MONEY DAMAGES WHETHER DIRECT OR
440 East Arrow Highway
San Dimas, CA 91773
909-599-5955
www.pertronix.com
GENERAL INFORMATION
Important
1.
: Read all instructions before starting installation.
Before the original distributor is removed, several settings should be noted;
2.
Base timing should be checked, and noted.
•
Position of vacuum advance canister should be noted.
•
Position of rotor should be noted.
•
Note:
•
If converting from a point style ignition , all primary Ignition resistance
should be removed. New HEI style spark plug wires will be necessary.
To check base timing, bring the engine up to normal operating temperature.
3.
Disconnect and plug the vacuum hose attached to the vacuum advance canis-
•
ter.
Connect timing light.
•
Start engine and check the base timing.
•
To ensure the
4.
Flame-Thrower™ distributor is installed correctly, note the direction in
which the vacuum advance canister points.
Remove the distributor cap, and note the position of the rotor. Once the
5.
Flamethrower distributor is installed the rotor position should be duplicated.
DISTRIBUTOR REMOVAL
Disconnect the negative battery cable.
1.
Disconnect the vehicle wiring harness, and distributor wiring harness from the
2.
distributor cap.
Remove the distributor cap, leaving the spark plug wires attached. Set the cap
3.
and wires out of the way.
Note the position of the distributor rotor. The vehicle should not be moved, and
4.
the engine should not be turned over until the installation is complete.
If converting from point type distributor, label the wires attached to the coil termi-
5.
nals and disconnect them. Remove the coil, and coil bracket from the engine.
Remove the vacuum hose attached to the vacuum canister.
6.
Remove the distributor hold down bolt and hold down.
7.
Remove the distributor by lifting up on the distributor housing while slightly turn-
8.
ing the rotor.
Check the distributor gear for signs of excess wear, or potential problems.
9.
TROUBLESHOOTING
If the vehicle fails to start after installing the Flame-Thrower distributor;
Check to insure that all directions have being followed correctly.
•
Make sure that all connections are correct, and tight.
•
If converting from a point type ignition, make sure that all primary resistance is
•
removed from the circuit.
•
For additional assistance call the Pertronix Tech Line at 909-599-5955
0017-004406
07/08
- Flame-Thrower HEI Distributors D1350 Flame-Thrower HEI Distributors D1202 Flame-Thrower HEI Distributors D1201 Flame-Thrower HEI Distributors D1200 Flame-Thrower HEI Distributors D1102 Flame-Thrower HEI Distributors D1101 Flame-Thrower HEI Distributors D1100 Flame-Thrower HEI Distributors D1052 Flame-Thrower HEI Distributors D1051 Flame-Thrower HEI Distributors D1050 Flame-Thrower HEI Distributors D1002 Flame-Thrower HEI Distributors D1001 Flame-Thrower HEI Distributors D1000