PerTronix Flame-Thrower Billet Distributors - Manual

BILLET DISTRIBUTOR
INSTALLATION INSTRUCTIONS
0019-008700 05/05
LIMITED WARRANTY
PerTronix, Inc. warrants to the original Purchaser of its Flame-Thrower billet
distributor that the product shall be free from defects in material and workmanship
(normal wear and tear excluded) for a period of 12 months from the date of
purchase.
If within the period of the foregoing warranty PerTronix finds, after inspection,
that the product or any component thereof is defective, PerTronix will, at its
option, repair such products or component or replace them with identical or simi-
lar parts PROVIDED that within such period Purchaser:
1. Promptly notifies PerTronix, in writing, of such defects.
2. Delivers the defective product or component to
PerTronix (Attn: Warranty) with proof of purchase date; and
3. Has installed and used the product in a normal and proper
manner, consistent with PerTronix printed instructions
THE FOREGOING LIMITED WARRANTY IS EXCLUSIVE AND IN LIEU OF
ALL OTHER WARRANTIES, WHETHER EXPRESS OR IMPLIED, INCLUDING
ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE.
THE FURNISHING OF A REPAIR OR REPLACEMENT COMPONENT OR
COMPONENTS SHALL CONSTITUTE THE SOLE REMEDY OF PURCHASER
AND THE SOLE LIABILITY OF PerTronix WHETHER ON WARRANTY, CON-
TRACT OR FOR NEGLIGENCE, AND IN NO EVENT WILL PerTronix BE LIABLE
FOR MONEY DAMAGES WHETHER DIRECT OR CONSEQUENTIAL.
440 East Arrow Highway
San Dimas, CA 91773
909-599-5955
www.pertronix.com
GENERAL INFORMATION
1.
IMPORTANT: Read all instructions before starting installation.
2. Flame-Thrower Billet distributors come with hardened steel distributor gears
which should not be used in applications with a billet camshaft. Consult
camshaft manufacturer for distributor gear compatibility.
3. Solid core spark plug wires MUST NOT be used.
4. Engines that have been decked, had significant cylinder head milling or oil
pump modification should be checked for oil pump bind and proper cam
gear engagement prior to installation.
DISTRIBUTOR REMOVAL
1.
Crank the engine until it is positioned at top dead center on a compression
stroke. The timing indicator should point to 0.
2. Remove the distributor cap, and make sure that the rotor is pointing
towards the first cylinder in the firing order.
3. Disconnect the battery negative (-) cable.
4. Disconnect all wires and hoses attached to the distributor.
5. Remove the distributor hold down.
6. Remove the distributor by lifting up on the distributor housing while slightly
turning the rotor.
7. Check the distributor gear for signs of excess wear, or potential problems.
DISTRIBUTOR INSTALLATION
1.
Remove the Flame-Thrower billet distributor cap.
2. Install the distributor gasket over the gear, and up to the distributor collar.
Use a small amount of gasket adhesive to help hold the gasket in place.
3. Lubricate the distributor gear and distributor shaft with clean engine oil.
4. Turn the shaft so that when the distributor is placed into the engine, the
rotor position matches that of the original distributor. As the distributor drops
down, the rotor will turn slightly as it engages with the camshaft gear.
Adjust for this rotation by turning the rotor a few degrees prior to the gear
engagement. Several attempts may be necessary to achieve the proper
rotor position. The distributor collar should sit completely flat on the intake
manifold or block.
5. Place the distributor cap onto the housing.
6. Turn the housing so that the terminal, that represents the first cylinder in
the firing order, lines up with the rotor.
7. Install the distributor hold down and tighten the hold down bolt slightly.
Once the ignition timing is adjusted the hold down bolt should be tightened
completely.