PerTronix Ignitor II 9MR-1122A - Manual

440 E. Arrow Highway, San Dimas, CA. 91773
909-599-5955 www.pertronix.com
LIMITED WARRANTY
Pertronix, Inc. Warrants to the original Purchaser of its solid-state ignition system
(product) that the Ignitor, magnet assembly and wiring (components) shall be free from
defects in material and workmanship for a period of (30) months from the date of purchase.
If within the period of the foregoing warranty Pertronix finds, after inspection, that
the product or any component thereof is defective, Pertronix will, at its option, repair such
products or component or replace them with identical or similar parts PROVIDED that within
such period Purchaser:
Promptly Notifies Pertonix, in writing, of such defects. 1.
Delivers the defective products product or component to Pertronix (ATTN: Warranty) 2.
with proof of purchase date; and
Has installed and used the product in a normal and Proper manner, consistent with
3.
Pertronix printed instructions.
THE FORGOING LIMITED WARRANTY IS EXCLUSIVE AND IN LIEU OF ALL
OTHER WARRANTIES, WHETHER EXPRESSED OR IMPLIED, INCLUDING AND IMPLIED
WARRANTY OR MERCHANTABILITY OR FITNESS FOR A PURPOSE.
THE FURNISHING OF A REPAIR OR REPLACEMENT COMPONENTS SHALL
CONSTITUTE THE SOLE REMEDY OF PURCHASER AND THE SOLE LIABILITY OF
PerTronix WHETHER ON WARRANTY, CONTRACT OR FOR NEGLIGENCE, AND IN NO
EVENT WILL PerTronix BE LIABLE FOR MONEY DAMAGES WHETHER DIRECT OR
CONSEQUENTIAL.
12-VOLT NEGATIVE GROUND INSTRUCTIONS
GENERAL INFORMATION
See our website (www.pertronix.com) for the latest product information. 1.
IMPORTANT: 2. Read all instructions before starting installation.
WARNING!!! DO NOT USE WITH SOLID CORE IGNITION WIRES. 3.
The Ignitor II ignition can be used in conjunction with most ignition coils rated at 0.45 ohms or 4.
greater.
All external resistors must be removed to achieve optimum performance from the Ignitor II ignition
5.
system.
The Ignitor II is compatible as a trigger for most electronic boxes.
6.
For Part Number: 9MR-161A, 9MR-1121A, 9MR-1122A
11-10
IGNITOR INSTALLATION
WARNING!!! DO NOT USE WITH SOLID CORE SPARK PLUG WIRES. 1.
Remove the distributor cap. Do not disconnect spark plug wires. Examine cap and rotor 2.
for wear or damage. Replace as needed.
Remove the rotor and the screws that hold the bearing support to the distributor
3.
housing. Remove the bearing support, snap ring and bearing. A bearing puller should
be used to prevent distributor damage.
Remove the point, condenser, and wire grommets from the distributor. If present,
4.
remove the point lubricating felt and bracket. Care must be taken that the aluminum
rivets holding the felt bracket do not drop into the distributor advance mechanism.
The Ignitor does not require any modification to distributor. Therefore the points,
5.
condenser and hardware can be used as backup.
Ignitor Plate Installation:
6.
MR-161 and MR-1122: Line up (X) on mounting plate to wire exit hole on distributor •
housing.
MR-1121: Line up (X) on mounting plate to
• either wire exit hole on distributor
housing.
Fasten the Ignitor mounting plate to the breaker plate using the provided screw.
•
Insert wires thru primary terminal exit hole and install wire grommet. Make sure all •
wires are clear of moving parts.
Place the magnet sleeve onto the point cam and press it down fully. 7. Note: Some point
cam variances might require minor opening of the magnet sleeve for proper fit.
Note: No air gap adjustment required.
8.
Install snap ring, bearing and bearing support. 9.
Install the rotor. 10.
Install the distributor per owners manual directions. 11.