PerTronix Ignitor II 9LU-1122A - Manual (Page 2)

WIRING INSTRUCTIONS
1. The Ignitor II ignition can be used in conjunction with most ignition coils rated
at 0.45 ohms or greater. For optimum performance purchase and install the
Flamethrower II high performance coil.
2. Attach the large ring terminal to the white wire exiting the distributor. Attach the
white wire to a good engine ground.
3. Route the ignitor black wire to the negative (-) side of the Ignitor coil. Cut the wire
to the appropriate lenght and crimp on the provided terminal. Attach the black
wire to the negative coil terminal.
4. Route the ignitor red wire to the positive (+) side of the ignition coil. Cut the wire
to the appropriate lenght and crimp on the provided ring terminal. Attach the red
wire to the postive coil terminal.
5. For optimum performance, it’s recomended that all external resistors be removed
or bypassed.
6. Reconnect battery and make sure all wires are connected securely.
+ -
To Ignition
11. Use the provided #6 screws to fasten the Ignitor plate to the plastic vacuum plate.
(See Illustration C).
12. Feed the wires through the hole in the distributor housing and pull the fgrommet
into place. Pull the excess wire out of the distributor housing.
13. Install the magnet sleeve onto the distributor shaft. Line the key way up and
press down fully.
14. Install the c-clip onto the distributor shaft.
15. Install; the distributor rotor and cap.
Attach the white wire to a good
engine ground.