Spektrum SPM7800 DX7S - Manual (Page 19)

19 SPEKTRUM DX7s • RADIO INSTRUCTION MANUAL
EN
Timer
The DX7s Timer function allows you to program a countdown
timer or stop watch (count up timer) to display on the main
screen. An alarm sounds when the programmed time is
reached. You can program the timer to start using the trainer
switch or automatically when throttle is raised above a
programmed position. An internal timer that shows run time for
a specific model displays on the Main Screen.
Monitor
The Monitor screen displays the servo positions for each chan-
nel graphically and numerically. This is useful to verify program-
ming functions, trim settings, mix directions, etc. The numeric
value is directly relative to the travel adjust and mix values (e.g.,
100% travel adjust equals 100% value in the Monitor).
Trainer
The DX7s features a programmable trainer function with three
trainer modes. The transmitter assigns the trainer function to
the trainer button. The function activates when you press the
trainer switch and select one of the three trainer modes. The
three trainer Modes include:
Inhibit
In Inhibit, the slave transmitter must have the same program-
ming as the master (e.g., servo reversing, travel adjust, sub-
trim, trims).
Programmable
With Programmable, you can program the transmitter to transfer
any or all channels when you activate the trainer switch. This
is ideal for beginners so the student learns control of individual
channels (aileron only for example) while the trainer maintains
control of all other channels.
The slave transmitter should be set to factory default settings
with Pilot Link Slave trainer type selected if available.
Pilot Link Master
When Pilot Link Master is selected, the slave transmitter has
control of the stick function only (aileron, elevator, rudder and
throttle) while the master maintains control of all other chan-
nels and functions (including D/R and switch positions). This is
ideal for complex models as the master maintains control of all
secondary functions and controls all other channels.
Slave
Use Slave mode when flying with the DX7s as a slave when the
master radio has activated its Pilot Link. In this case, there is
no need to match programming between the slave and master
transmitter.
DX7s Trainer Operation
• Bind the transmitter to the model
• Connect the controlling trainer cord (SMP6805) to the back
of the master transmitter.
• Make sure the slave transmitter batteries are charged.
• Make sure the slave transmitter is powered off; the slave
transmitter receives power when you connect the trainer
cord.
• Connect the trainer cord to the slave transmitter.
• The slave transmitter screen will show information but will
not send a signal to the model.
• Release the button on the master transmitter for the master
transmitter to regain control of the model.