beautypg.com

Year limited warranty, 4ghz troubleshooting guide, En fcc information – Spektrum SPM2300 DX2E User Manual

Page 4: Caution, Antenna separation distance, What this warranty covers, What is not covered, Purchaser’s remedy

background image

4

SPEKTRUM DX2E USER GUIDE

EN

FCC INFORMATION

This device complies with part 15 of the FCC rules.

Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this

device must accept any interference received, including

interference that may cause undesired operation.

CAUTION

: Changes or modifications not expressly

approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

This product contains a radio transmitter with wireless

technology which has been tested and found to be compliant

with the applicable regulations governing a radio transmitter

in the 2.400GHz to 2.4835GHz frequency range.

ANTENNA SEPARATION DISTANCE

When operating your Spektrum transmitter, please be sure

to maintain a separation distance of at least 5 cm between

your body (excluding fingers, hands, wrists, ankles and feet)

and the antenna to meet RF exposure safety requirements

as determined by FCC regulations.
The following illustrations show the approximate 5 cm RF

exposure area and typical hand placement when operating

your Spektrum transmitter.

1-yEAR LIMITED WARRANTy

WhAT ThIS WARRANTy COvERS

Horizon Hobby, Inc. (“Horizon”) warrants to the original

purchaser that the product purchased (the “Product”) will be

free from defects in materials and workmanship for a period of

1 year from the date of purchase by the Purchaser.

WhAT IS NOT COvERED

This warranty is not transferable and does not cover (i)

cosmetic damage, (ii) damage due to acts of God, accident,

misuse, abuse, negligence, commercial use, or due to

improper use, installation, operation or maintenance, (iii)

modification of or to any part of the Product, (iv) attempted

service by anyone other than a Horizon Hobby authorized

service center, or (v) Products not purchased from an

authorized Horizon dealer.
OTHER THAN THE EXPRESS WARRANTY ABOVE, HORIZON

MAKES NO OTHER WARRANTY OR REPRESENTATION, AND

HEREBY DISCLAIMS ANY AND ALL IMPLIED WARRANTIES,

INCLUDING, WITHOUT LIMITATION, THE IMPLIED

WARRANTIES OF NON-INFRINGEMENT, MERCHANTABILITY

AND FITNESS FOR A PARTICULAR PURPOSE. THE

PURCHASER ACKNOWLEDGES THAT THEY ALONE HAVE

DETERMINED THAT THE PRODUCT WILL SUITABLY MEET THE

REQUIREMENTS OF THE PURCHASER’S INTENDED USE.

PURChASER’S REMEDy

Horizon’s sole obligation and purchaser’s sole and exclusive

remedy shall be that Horizon will, at its option, either (i)

service, or (ii) replace, any Product determined by Horizon

to be defective. Horizon reserves the right to inspect any

and all Product(s) involved in a warranty claim. Service or

replacement decisions are at the sole discretion of Horizon.

Proof of purchase is required for all warranty claims. SERVICE

OR REPLACEMENT AS PROVIDED UNDER THIS WARRANTY IS

THE PURCHASER’S SOLE AND EXCLUSIVE REMEDY.

2.4Ghz TROUBLEShOOTING GUIDE

Problem

Possible Cause

Solution

The system will not

connect

Your transmitter and receiver are too close

together

Move transmitter 8 to 12 feet from receiver

You are around metal objects

Move to an area with less metal

The model selected is not the model bound to

Check model selected and ensure you are bound to

that model

Your transmitter was accidentally put into bind

mode and is no longer bound to your receiver

Rebind your transmitter and receiver

The receiver goes into

failsafe mode a short

distance away from the

transmitter

Check the receiver antenna to be sure it is not

cut or damaged

Replace the receiver or contact Horizon Product

Support

Make sure your receiver antenna is in an antenna

tube and is above the vehicle

The receiver quits

responding during

operation

Inadequate battery voltage

Charge batteries. Spektrum receivers require at least

3.5V to operate. An inadequate power supply can

allow voltage to momentarily drop below 3.5V and

cause the receiver to brown out and reconnect

Loose or damaged wires or connectors between

battery and receiver

Check the wires and connection between the ba-

ttery and receiver. Repair or replace wires and/or

connectors

This manual is related to the following products: