Allied Telesis AT-FS217 - Manual (Page 34)

Translated Safety and Emission Information
22
Standards: This product meets the following standards.
!
1 RFI Emission EN55022 Class B
!
2 Warning: In a domestic environment this product may cause radio interference in
which case the user may be required to take adequate measures.
!
3 Immunity EN55024
!
4 Warning: This product requires shielded cables to comply with emission and
immunity standards. If it is used with unshielded cables, the user may be required
to take measures to correct the interference problem at their own expense.
!
5 Electrical Safety EN60950 (TUV), UL1950 (UL/cUL)
!
6 Laser EN60825
Safety
!
7 Warning Class 1 Laser product. (AT-FS212/x models)
U.S. Federal Communications Commission
Declaration Of Conformity
Manufacture Name: Allied Telesyn, Inc.
Manufacture Address: 960 Stewart Drive, Suite B
Sunnyvale, CA 94085 USA
Manufacture Telephone: 408-730-0950
Declares that the product: Fast Ethernet Switches
Model Numbers: AT-FS211, AT-FS212, AT-FS212/1,
AT-FS214, AT-FS215, AT-FS216,
AT-FS217
This product complies with FCC Part 15B, Class B Limits:
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device must not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Radiated Energy
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device pursuant to Part 15 of FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with instructions, may cause
harmful interference to radio or television reception, which can be determined by
turning the equipment off and on. The user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and the receiver.
- Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes and modifications not expressly approved by the manufacturer or
registrant of this equipment can void your authority to operate this equipment
under Federal Communications Commission rules.
Industry Canada
This Class B digital apparatus meets all requirements of the Canadian
Interference-Causing Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement
sur le matériel brouilleur du Canada.