Allied Telesis AT-FS217 - Manual (Page 25)

AT-FS21x and AT-FS212/x Series Installation Guide
13
b. Plug the AC power cord to a power outlet.
Note
To prevent the DC power cable from being inadvertently pulled out of
the switch, use the cable tie supplied with the unit to secure the DC
power cable to the cable hook located next to the DC connector.
9. Verify that the PWR LED on the switch is green. If the LED is OFF, refer
to “Troubleshooting” on page 15.
10. Remove the dust cover from the 100Base-FX fiber optic port and connect
the fiber optic cable.
11. Connect the twisted pair cable to the 10/100Base-TX port.
12. Power ON the end-nodes. The TX and FX LEDs should be green. If the
LEDs are OFF, refer to “Troubleshooting” on page 15.
The switch is now ready for use.
Warranty Registration
When you finish installing the product, you should register your product by
completing the enclosed warranty card and sending it in.