Allied Telesis AT-10408XP - Manual (Page 41)

AT-10408XP 10-Gigabit Ethernet Switch Installation Guide
41
Starting a Local Management Session
To start a local management session on an AT-10408XP 10-Gigabit
Ethernet Switch, perform the following procedure:
1. Connect one end of the RJ-45 style RS-232 terminal cable to the
terminal port on the switch, as shown in Figure 19.
Figure 19. Connecting the RJ-45 Style Terminal Cable
2. Connect the other end of the cable to the port on a terminal or PC with
a terminal emulator program.
3. Configure the terminal or terminal emulator program as follows:
ˆ Baud rate: 9600
ˆ Data bits: 8
ˆ Stop bits: 1
ˆ Flow control: None
Note
These default settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulation program.
1. Type the user id and password.
There are two default user ids and passwords. For the system
administrator login, the default user id is “manager” and the default
password is “friend.” For the operator login, the default user id is
“operator” and the default password is “operator.”
7
XFP 8
XFP
STATUS
FAULT
MASTER
PSU1
PSU2
SD 10/100 LI NK ACT
1000 LI NK ACT TER MINAL POR
T
10/100/1000Base-
T
BUSY
NORM AL
FAULT
1218