Allied Telesis AT-10408XP - Manual (Page 38)

Chapter 2: Installation
38
Cabling and Powering On the Switch
Connecting a
XFP Fiber Optic
Cable
To connect a fiber optic cable to an XFP installed in the AT-10408XP 10-
Gigabit Ethernet Switch, perform the following procedure:
1. Remove the dust plug from the XFP, as shown in Figure 14.
Figure 14. Removing the Dust Cover from the XFP
2. Connect the fiber optic cable to the XFP port, as shown in Figure 15.
Figure 15. Connecting the Fiber Optic Cable
7
XFP
8
XFP
STATUS
FAULT
MASTER
PSU1
PSU2
SD 10/100 LI NK ACT
1000 LI NK ACT TER MINAL POR
T
10/100/1000Base-
T
BUSY
NORMAL
FAULT
1216
7
XFP 8
XFP
STATUS
FAULT MASTER
PSU1
PSU2
SD 10/100 LI NK ACT
1000 LIN K ACT TER MINAL PO RT
10/100/1000Base-
T
BUSY
NORM AL
FAULT
1215