Allied Telesis AlliedView-EMS 3.10 INSTALLATION - Manual (Page 16)

AlliedView™-EMS 3.10 INSTALLATION GUIDE Page 16 of 29
6 INTEGRATING ALLIEDVIEW-EMS 3.10 WITH SNMPC
The AlliedView-EMS 3.10 installer automatically detects if SNMPc is installed and will perform the
necessary integration so that AlliedView-EMS 3.10 can be started from within SNMPc. If AlliedView-
EMS 3.10 is installed before SNMPc, integration will not take place. Reinstallation of AlliedView-EMS
3.10 will be required.
Note - For Device Manager to run properly on the console component of SNMPc, AlliedView-EMS
should be installed with SNMPc integration on both the Server and Console PCs.
When SNMPc is running, double clicking on a device that is not supported by AlliedView-EMS
launches SNMPc’s BitView program. Double clicking on a device supported by AlliedView-EMS
launches the Device Manager application and loads the information for the selected device.
If you are using SNMPc version 5.1.6c and you launched SNMPc for the first time after integration
with AlliedView-EMS 3.10 is done, a message box appears informing you that the newly detected MIB
files will be compiled. Click Done after compilation process is completed. For SNMPc version 6.0,,
7.0, and 7.1, compilation of MIB files is done automatically.