Allied Telesis AT-S63 - Manual (Page 306)

Chapter 28: Internet Protocol Version 4 Packet Routing
306 Section VII: Routing
Supported Platforms
This feature is supported on the following switches:
ˆ Layer 2+ Models
– Not supported
Note
Although the Layer 2+ models do not support IP packet routing. you
can create one IP routing interface on the switches to assign them
an IP configuration. This is required by some of the management
features. For further information, refer to “Routing Interfaces and
Management Features” on page 324 and “AT-9408LC/SP
AT-9424T/GB, and AT-9424T/SP Switches” on page 328.
ˆ Basic Layer 3 Models
– AT-9424T
– AT-9424T/POE
– AT-9424Ts
– AT-9424Ts/XP
– AT-9448T/SP
– AT-9448Ts/XP
ˆ Stack of Basic Layer 3 Switches
– Supports static routes but not RIP.
This feature can be managed on a stand-alone switch from the following
management interfaces:
ˆ Command line
ˆ Menus (You can use the menus to configure the routing interfaces, but
not static routes or RIP. To configure all of the feature’s components,
use the command line.)
To configure this feature on a stack you have to use the command line.
This feature is not supported in the web browser interface.