Allied Telesis AT-S63 - Manual (Page 53)

AT-S63 Management Software Features Guide
53
may lessen the impact to network operations if the stack encounters a
problem.
Version 3.2.0 This release added support for these features in AT-9400Ts Stacks:
ˆ Remote web browser management
ˆ Link Aggregation Control Protocol (LACP) trunks
ˆ Internet Group Management Protocol (IGMP) snooping
ˆ Internet Protocol Version 4 packet routing with static routes (Stacks do
not support the Routing Information Protocol (RIP) or multipath
routing.)
ˆ Basic 802.1x port-based network access control (Stacks do not
support MAC address-based authentication, Guest VLANs, or
supplicant and VLAN associations.)
For a complete list of the features supported in a stack, refer to the
Software Release Notes for the AT-S63 Version 3.2.0 Management
Software or to the AT-S63 Stack Command Line User’s Guide.
Version 3.2.0 did not include any new features for stand-alone AT-9400
Switches.
Version 3.0.0
Table 21 lists the new features in version 3.0.0 of the AT-S63
Management Software.
Table 21. New Features in AT-S63 Version 3.0.0
Feature Change
Stacking with the AT-StackXG
Stacking Module New feature. For information, refer
to Chapter 1, Overview in the
AT-S63 Stack Command Line
Interface User’s Guide.
Virtual Router Redundancy
Protocol (VRRP) New feature. For information, refer
to Chapter 31, “Virtual Router
Redundancy Protocol” on page
361.
Ethernet Protection Switching
Ring (EPSR) snooping New feature. For information, refer
to Chapter 20, “Ethernet
Protection Switching Ring
Snooping” on page 209.
Internet Protocol version 4 packet
routing Added the following new features:
ˆ Split horizon with poison
reverse
ˆ Auto-summarization of routes
ˆ DHCP/BOOTP relay