Allied Telesis AT-S63 - Manual (Page 333)

AT-S63 Management Software Features Guide
Section VII: Routing 333
Note
A RIP version 2 password is sent in plaintext. The AT-S63
Management Software does not support encrypted RIP passwords.
The switch transmits its routing table every thirty seconds from those
interfaces that have RIP. This interval is not adjustable on the switch. The
entire table is sent with the following exceptions:
ˆ Dynamic RIP routes that fall under the split horizon rule.
ˆ Inactive interface routes where there are no active ports in the VLAN.
Note
The AT-S63 Management Software does not support the RIP
holddown and flush timers.
The commands for managing RIP are ADD IP RIP, DELETE IP RIP, and
SET IP RIP.
Note
RIP must be configured from the command line interface. The
menus and web browser interfaces do not support this feature.
The AT-9400 Switch supports the following RIP functions:
ˆ Split horizon
ˆ Split horizon with poison reverse
ˆ Autosummarization of routes