Allied Telesis AT-9448Ts/XP (Basic Layer 3) - Manual (Page 54)

Chapter 3: Preparing the Switches
54
Verifying the AT-S63 Version Number
After you have logged on, the command line interface (CLI) prompt,
shown in Figure 22, is displayed.
Figure 22. Command Line Prompt
The version number of the AT-S63 Management Software on the switch is
displayed after “AT-S63.” In the example it‘s “V4.0.0.”
Note the following:
 The management software must be version 3.0.0 or later.
 All the switches of a stack must have the same version of the
management software.
If you need to upgrade the management software on the switch, go to the
next procedure. Otherwise, go to “Assigning the Static Module ID Number
1 to the Master Switch” on page 56 if you are configuring the master
switch of “Assigning Static Module ID Numbers to the Member Switches”
on page 59 if you are configuring a member switch.
Allied Telesis Ethernet Switch AT-9424Ts/XP - AT-S63 v4.0.0
#