Allied Telesis AT-FS750/48 - Manual (Page 44)

Chapter 2: Installation
44
Installing an SFP Transceiver
The AT-FS750/48 Fast Ethernet WebSmart switch has four SFP combo
ports. Perform this procedure before “Cabling and Powering On the
Switch” on page 46.
To install an SFP transceiver, perform the following procedure:
Note
The transceiver can be hot-swapped; you do not need to power off
the switch to install a transceiver. However, always remove the
cables before removing the transceiver.
Note
You must install the transceiver before you connect cables to it.
1. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
2. Remove the dust plug from the SFP slot, as shown in Figure 14.
Figure 14. Removing the Dust Plug from the SFP Slot
3. Locate the label on the transceiver and turn it so that the label is on top
and the alignment groove is on the bottom.
1714 48 Port 10/100 Mbps
WebSmar
t Switch with 2 Combo SFP
Ports
1737