beautypg.com

5 configuration (windows) – Allied Telesis AlliedView-EMS 4.0.2 INSTALLATION User Manual

Page 17

background image


AlliedView™-EMS 4.0.2 INSTALLATION GUIDE

Page 17 of 31

4.2

HP-UX

To install AlliedView-EMS 4.0.2 on HP-UX, perform the following procedure.

1. Make sure that you have root privilege.

2. Copy the EMS402H.bin file to a temporary directory.
3. Move to the directory where the installation file is.

4. Make sure that the installation file is executable. Use the chmod command to correct

the permissions mode of the file.

chmod u+x EMS402H.bin

5. Enter the following on the command line:

./EMS402H.bin

6. Press Enter to start the AlliedView-EMS 4.0.2 installer. The AlliedView-EMS 4.0.2 splash

screen is displayed for a few seconds then the installation wizard will appear. Use the

same procedure as the Windows procedure to install AlliedView-EMS 4.0.2 on your
UNIX machine.

4.3

SOLARIS

To install AlliedView-EMS 4.0.2 on Solaris, perform the following procedure.

1. Make sure that you have root privilege.

2. Copy the EMS402S.bin file to a temporary directory.

3. Move to the directory where the installation file is.
4. Make sure that the installation file is executable. Use chmod command to correct the

permission mode of the file.

chmod u+x EMS402S.bin

5. Enter the following on the command line:

./EMS402S.bin

6. Press Enter to start the AlliedView-EMS 4.0.2 installer. The AlliedView-EMS 4.0.2 splash

screen is displayed for a few seconds then the installation wizard will appear. Use the

same procedure as the Windows procedure to install AlliedView-EMS 4.0.2 on your

UNIX machine.

5 CONFIGURATION (WINDOWS)

To run AlliedView-EMS 4.0.2 from the command line on Windows, configure the environment

variable PATH to point to the directory containing the AlliedView-EMS 4.0.2 executable. For
example, if AlliedView-EMS 4.0.2 is installed in C:\Program Files\Allied Telesis\AlliedView-EMS\bin, set

the PATH variable as follows:


set PATH=%PATH%;C:\Program Files\Allied Telesis\AlliedView-EMS\bin

This statement can be written in the C:\AUTOEXEC.BAT file, which is automatically executed at
system boot.