Allied Telesis AlliedView-EMS 4.0.2 INSTALLATION - Manual (Page 10)

AlliedView™-EMS 4.0.2 INSTALLATION GUIDE Page 10 of 31
Select No and click Next if you do not wish to check for the latest version of
AlliedView-EMS. The installer will then proceed to the next window.
5. If you plan to integrate AlliedView-EMS 4.0.2 with an NMS, the NMS should be in the
correct state:
•
For SNMPc and OpenView, services should not be running.
•
For NetView, services should be running.
The next window is displayed if the installer has detected that your NMS is not in its
correct state.
If you plan to integrate AlliedView-EMS 4.0.2 with SNMPc or OpenView, select No and
click Next to continue. Selecting No will terminate the installation setup program. You
will then need to stop SNMPc or OpenView services and start the installer again.
If you do not plan to integrate AlliedView-EMS 4.0.2 with SNMPc or OpenView, select
Yes and click Next to continue. The installer will then proceed to the next window.
Note that the opposite applies for NetView. The window will be displayed if NetView
services are not running.
6. Specify whether you want to install both the AlliedView-EMS 4.0.2 application and its
documentation. You also have the option to install either the application or the
documentation only.