Allied Telesis AT-WA7400 - Manual (Page 43)

AT-WA7400 Wireless Access Point Installation Guide
41
To start the discovery process, perform the following procedure:
1. Do one of the following to create an Ethernet connection
between the access point and your computer:
ˆ Connect one end of an Ethernet cable to the LAN port on the
access point and the other end to the same hub where your
PC is connected.
ˆ Connect one end of an Ethernet cable to the LAN port on the
access point and the other end of the cable to the Ethernet
port on the your PC.
2. Insert the AT-WA7400 Wireless Access Point CD into the CD-
ROM drive on your computer.
The CD’s main page is shown in Figure 11.
Figure 11. AT-WA7400 CD Main Page
3. Click KickStart Utility.