Allied Telesis AT-WA7400 - Manual (Page 42)

Chapter 2: Installation
40
Running KickStart to Find Access Points on
the Network
KickStart is an easy-to-use utility for discovering and identifying
new AT-WA7400 Wireless Access Points. KickStart scans the
network looking for access points, displays ID details on those it
finds, and provides access to the AT-WA7400 Management
Software.
Note
KickStart (and the other AT-WA7400 tools) recognizes and
configures only AT-WA7400 Wireless Access Points. KickStart
does not find or configure non-AT-WA7400 Wireless Access
Points and will not find any other devices.
Note
Run KickStart only in the subnet of the internal network ( SSID ).
Note
KickStart finds only those access points that have IP addresses.
IP addresses are dynamically assigned to access points if you
have a
DHCP server running on the network. If you deploy the
access point on a network with no DHCP server, the default
static IP address (192.168.1.230) is used.
Caution
Use caution with non-DHCP enabled networks: Do not
deploy more than one new access point on a non-DHCP
network because they will use the same default static IP
addresses and conflict with each other.