Asus P3V4X - Manual (Page 35)

ASUS P3V4X User’s Manual 35
3. HARDWARE SETUP
Connectors
3. H/W SETUP
8. IDE Device Activity LED (2-pin IDELED)
This connector supplies power to the cabinet’s IDE device activity LED. Read
and write activity by devices connected to the Primary or Secondary IDE con-
nectors will cause the LED to light up.
R
P3V4X
P3V4X IDE Activity LED
TIP: If the case-mounted LED does not light,
try reversing the 2-pin plug.
IDELED
9. Wake-On-Ring Connector (2-pin WOR)
This connector connects to internal modem cards with a Wake-On-Ring output.
The connector powers up the system when a ringup packet or signal is received
through the internal modem card. NOTE: For external modems, Wake-On-Ring
is detected through the COM port.
IMPORTANT: This feature requires that the PWR UP On External Modem
Act is set to Enabled (see 4.5.1 Power Up Control).
R
P3V4X
P3V4X Wake-On-Ring Connector
WOR
PIXRI# Ground
2 1