Asus P3V4X - Manual (Page 15)

ASUS P3V4X User’s Manual 15
3. HARDWARE SETUP
3.2 Layout Contents
Motherboard Settings
1) JEN p. 17 JumperFree™ Mode (Enable/Disable)
2) U12-Switches 5 & 6 p. 17 AGP Bus Frequency Setting
3) U12-Switches 7–10 p. 18 CPU Bus Frequency Selection
4) U12-Switches 1–4 p. 19 CPU Core:BUS Frequency Multiple
Expansion Slots/Sockets
1) DIMM1, -2, -3, -4 p. 20 DIMM Memory Module Support
2) Slot 1 p. 23 CPU Support
3) PCI1,-2, -3, -4, -5, -6 p. 29 32-bit PCI Bus Expansion Slots
4) SLOT2 p. 30 16-bit ISA Bus Expansion Slots *
6) AGP p. 31 Accelerated Graphics Port
Connectors
1) PS2KBMS p. 32 PS/2 Mouse Port Connector (6 pin-female)
2) PS2KBMS p. 32 PS/2 Keyboard Port Connector (6-pin female)
3) PARALLEL p. 33 Parallel (Printer) Port Connector (25-pin female)
4) COM1, COM2 p. 33 Serial Port COM1 & COM2 (two 9-pin male)
5) USB p. 33 Universal Serial BUS Port Connectors 1 & 2 (Two 4-pin female)
6) Primary/Secondary IDE p. 34 Primary/Secondary IDE Connectors (Two 40-1 pins)
7) FLOPPY
p. 34 Floppy Drive Port Connector (34 pins)
8) IDELED p. 35 IDE LED Activity Light (2 pins)
9) WOR p. 35 Wake-On-Ring Connector (2 pins)
10) CHA_, PWR_, CPU_FAN p. 36 Chassis, Power Supply, CPU Fan Power Lead (3 pins)
11) WOL_CON
p. 37 Wake-On-LAN Connector (3 pins)
12) IR p. 37 Infrared Port Module Connector (5 pins)
13) SMB p. 38 SMBus Connector (3 pins)
14) JTPWR p. 38 Thermal Sensor Connector
15) ATXPWR p. 39 ATX Motherboard Power Connector (20 pins)
16) CHASSIS p. 39 Chassis Intrusion Alarm Lead (4-1 pins)
17) PWR.LED (PANEL) p. 40 System Power LED Lead (3-1 pins)
18) KEYLOCK (PANEL) p. 40 Keyboard Lock Switch Lead (2 pins)
19) SPEAKER (PANEL) p. 40 System Warning Speaker Connector (4 pins)
20) MSG.LED (PANEL) p. 40 System Message LED (2 pins)
21) SMI (PANEL) p. 40 System Management Interrupt Lead (2 pins)
22) PWR.SW (PANEL) p. 40 ATX Power / Soft-Off Switch Lead (2 pins)
23) RESET (PANEL) p. 40 Reset Switch Lead (2 pins)
* The optional onboard hardware monitor uses the address 290H-297H so legacy ISA cards
must not use this address otherwise conflicts will occur.
Layout Contents
3. H/W SETUP