Using the ice off function, Going on vacation, Ice maker do’s and don’ts – Samsung RF24FSEDBSR User Manual
Page 149: Water clouding phenomenon
operating
_29
02 OPERA
TING
Using the ice off Function
When you select the Ice Off mode, remove all ice
cubes from the bucket.
If you leave the ice cubes in the bucket, the ice
cubes may clump together, making it diffi cult to
remove them.
To remove the ice bucket safely and avoid injury,
hold the bottom of the bucket with one hand and
the side of the bucket with the other.
Then, lift up on the ice bucket, and pull it straight
out.
To put the ice bucket back in, push it fi rmly
straight back.
If the ice bucket is not pushed fi rmly into
place, ice in the bucket can melt.
If the bucket does not fi t, turn the helix 90 degree
(see the last illustration on the right, below) and try
again.
• The inside of the ice bucket is very cold
when the refrigerator is operating.
Do not reach deep inside the ice
bucket.
• Use only the ice maker provided with
the refrigerator. The water supply to this
refrigerator must only be installed/connected
by a suitably qualifi ed person.
Connect to a potable water supply only.
• To operate the ice maker properly, water
pressure of 20 ~ 125 psi is required.
CAUTION
Going on vacation...
If you have a long vacation or business trip and
won’t use the water or ice dispensers for a long
time:
-
Close the water valve. Otherwise, water
leakage may occur.
-
Remove all food.
-
Unplug the refrigerator.
-
Wipe excess moisture from inside and leave
the doors open. Otherwise, odor and mold
may develop.
Ice Maker Do’s and Don’ts
• Do not put your fi ngers, hands or any other
unsuitable objects in the chute or ice-maker
bucket
-
It may result in personal injury or material
damage.
• Never put your fi nger or any other objects in
the dispenser opening.
-
It may cause injury.
• Do not try to disassemble the ice maker.
• Do not wash or spray the ice bucket with
water while it is in the refrigerator. Remove it
to clean it.
When you insert the Ice maker tray, be
sure that the tray is well centered at the
entrance.
Otherwise, the tray may get stuck.
Water clouding phenomenon
All water provided to the refrigerator fl ows
through the core fi lter which is an alkaline
water fi lter. In the fi ltering process, the
pressure of the water that has fl owed out
of the fi lter is increased, and the water
becomes saturated with oxygen and
nitrogen. When this water fl ows out into
the air, the pressure plummets and the
oxygen and nitrogen get supersaturated,
which results in gas bubbles. The water
may temporarily look misty or cloudy due
to these oxygen bubbles. After a few
seconds, the water will look clear.
CAUTION
DA68-02916G-08.indb 29
DA68-02916G-08.indb 29
2014. 6. 20.
9:20
2014. 6. 20.
9:20