Disassemble the refrigerator doors – Samsung RF24FSEDBSR User Manual

Page 137

setting up

_17

01 SETTING

Disassemble the refrigerator doors

Be careful not to drop and scratch the
doors while removing them.

With the door opened
1. Remove the 3 screws holding down the TOP

TABLE ( 1 ) and separate the connected wires.

2. Disconnect the two connectors ( 2 ) on the

left side door. To remove the water coupler
from the hinge, twist and pull it from the hinge.
Remove the water line ( 3 ) while pressing the
marked part ( 4 ) of the water line coupler.

If a red clip is on the coupler, you must
remove it before removing the tube.

Red Clip

(6 mm)

3. Pull and remove the hinge lever ( 5 ). Remove

the ground screw ( 6 ) attached to the upper
left door hinges with a philips screwdriver (+).
Remove the upper left and right door hinges
( 7 ).

4. Open the door (more than 90°), lift from the

middle hinge and remove the door.

WARNING

CAUTION

Due to its design features, you can
disassemble and re-assemble the door when
the door is open. (The holes in the Door Shaft
and the Door Middle Hinge are deliberately
tilted at speciﬁ c angles so that it is difﬁ cult to
disassemble and re-assemble with the door
closed.)

Place the door, inside facing up, on a non-
scratching surface.

Auto Closing Hinge

Check the direction

Door Middle Hinge

If the Auto Closing Hinge is aligned to be
vertical as shown in the ﬁ gure, align it to be
parallel by using the Door Middle Hinge. (Refer
to No.5 for the disassembly of the Door Middle
Hinge)

Do not use a ﬂ at head screwdriver to align
the Auto close Hinge. It may get damaged.
Use the Door middle Hinge instead.

5. Remove the screw ( 8 ) attached to the

lower left and right door hinges with a philips
screwdriver (+). Remove the 2 hex head bolts
( 9 ) attached to the lower left and right door
hinges with an allen wrench (5 mm). Remove
the lower left and right door hinges ( 10 ).

Allen wrench

CAUTION

DA68-02916G-08.indb 17

2014. 6. 20.

9:20

2014. 6. 20.

9:20