APC RAID Subsystem SCSI-SATA II - Manual (Page 20)

- 20 -
Default password: 00000000
2.9 Enclosure
2.9.1 LCM
There are four buttons to control IS16GL LCM (LCD Control Module), including:
• (up), ‚ (down),
(Escape), and (Enter).
After booting up the system, the following screen shows management port IP and
model name:
192.168.10.50
IS16GL ←
Press “
”, the LCM functions “Alarm Mute”, “Reset/Shutdown”, “Quick
Install”, “View IP Setting”, “Change IP Config” and “Reset to Default” will
rotate by pressing • (up) and ‚ (down).
When there is WARNING or ERROR level of event happening, the LCM shows
the event log to give users more detail from front panel too.
The following table is function description.
Alarm Mute Mute alarm when error occurs.
Reset/Shutdown Reset or shutdown controller.
Quick Install Quick three steps to create a volume. Please refer to
section 3.3 for operation in web UI.
View IP Setting Display current IP address, subnet mask, and gateway.
Change IP
Config Set IP address, subnet mask, and gateway. There are 2
selections, DHCP (Get IP address from DHCP server) or
set static IP.
Tips
SB-3164-G1A3 Series only support SSH for remote control.
For using SSH, the IP address and the password is required
for login.