Samsung UN78HU9000FXZA - Manual (Page 211)

204 205
Anynet+ (HDMI-CEC) isn't working.
The Problem Try this!
Anynet+ does not
work.
Confirm that the device is an Anynet+ device. The Anynet+ system supports
Anynet+ devices only.
Check if the power cord of the Anynet+ device is properly connected.
Check the cable connections of the Anynet+ device.
Go to
System and see if Anynet+ (HDMI-CEC) has been set to On .
Check whether the TV remote control is in TV mode.
Check whether the remote control is Anynet+ compatible.
Anynet+ may not function when some other functions are active, including Channel
Search, Smart Hub, Start Up, etc.
If you have disconnected and then reconnected the HDMI cable, scan for devices
again or turn your TV off and on.
HDMI UHD Color
is specific to a UHD source, and does not operate properly for
any other source. In this case, navigate
Picture
>
Picture Options
>
HDMI UHD
Color menu, and then set the HDMI UHD Color -enabled HDMI connector to Off .
I want to start
Anynet+.
Check if the Anynet+ device is properly connected to the TV, and then navigate to
the
System menu to see if Anynet+ (HDMI-CEC) is set to On .
Once you have verified that Anynet + is on:
"
On the Samsung Smart Control, press the
KEYPAD
button, and then select
the
TOOLS
button on the On-Screen Remote. A list appears. Select
Anynet+
(HDMI-CEC)
from the list, and then a device.
"
On a standard remote, press the TOOLS button. A list appears. Select
Anynet+ (HDMI-CEC)
from the list, and then a device.
I want to exit Anynet+.
Select View TV from the Anynet+ menu.
Select a non-Anynet+ device from the Source list.
The message
"Connecting to
Anynet+ device..."
or "Disconnecting
from Anynet+ device"
appears on the screen.
You cannot use the remote control when you are configuring Anynet+ or switching
to a viewing mode. Use the remote control after the TV has completed the Anynet+
configuration or has switched to a viewing mode.
The Anynet+ device
won't play.
You cannot use the play function when
Setup
is in progress.
The connected device
is not displayed.
Check whether the device supports Anynet+.
Check whether the HDMI cable is properly connected.
Go to
System
and see if
Anynet+ (HDMI-CEC)
has been set to
On
.
Scan for Anynet+ devices again.
Anynet+ devices must be connected to the TV using an HDMI cable. Make sure the
device is connected to your TV with an HDMI cable. Some HDMI cables may not
support Anynet+.
If the connection is terminated because there has been a power failure or the HDMI
cable has been disconnected, please scan for the device again.
The TV audio is not
being played through
the receiver.
Connect an optical cable to the TV and the receiver.
ARC enables the TV to output digital sound via the HDMI (ARC) port.
However, ARC is only available when the TV is connected to an audio receiver that
supports ARC.