Samsung HT-TXQ120T-XAA - Manual (Page 26)

ENG
SETUP
51 50
If the speakers cannot be placed at equal distances from the listening position, you can adjust the delay time of the audio
signals from the center and rear speakers.
1 In Stop mode, press the MENU button.
2 Press the Cursor button to move to and then press the ENTER button.
3 Press the Cursor button to move to and then press the
ENTER button.
4 Press the Cursor , , , button to move to the desired speaker and then
press the ENTER button.
5 Press the Cursor , button to set the Delay time.
You can set the delay time for C between 00 and 05mSEC and for SL and SR between 00 and
15mSEC.
Press the RETURN button to return to the previous level.
Press the MENU button to exit the setup screen.
Setting the Delay Time
When 5.1CH Surround Sound is played, you can enjoy the best sound if the distance between you and each speaker is the same.
Since the sounds arrive at the listening position at different times depending on the placement of speakers, you can adjust this difference by
adding a delay effect to the sound of the Center and Surround Speakers.
Setting CENTER SPEAKER
If the distance of Dc is equal to or longer than the distance of Df in the figure,
set the mode as 0ms. Otherwise, change the setting according to the table.
Setting REAR (SURROUND) SPEAKERS
If the distance of Df is equal to the distance of Ds in the figure, set the mode
as 0ms. Otherwise, change the setting according to the table.
Setting up the Speaker Delay Time
Df: The distance from FRONT SPEAKER
Dc: The distance from CENTER SPEAKER
Ds: The distance from SURROUND SPEAKER
Ideal CENTER SPEAKER
placement
It is desirable to place all speakers within this circle.
Ideal
SURROUND
SPEAKER
placement
Distance between Df and Dc
Delay Time
0 inch 13.6 inches 27.2 inches 40.8 inches 4.5 feet 5.6 feet
0 ms 1 ms 2 ms 3 ms 4 ms 5 ms
Distance between Df and Dc
Delay Time
0 inch 40.8 inches 6.7 feet 10.0 feet 13.4 feet 16.7 feet
0 ms 3 ms 6 ms 9 ms 12 ms 15 ms
• With (Dolby Pro Logic II), the delay time may be
different for each mode.
• With AC-3 and DTS, the delay time can be set between 00 and
15mSEC.
• The Center channel is only adjustable on 5.1 channel discs.
Settings
(Con’t)
Use the Test Tone feature to check the speaker connections.
1 In Stop mode, press the MENU button.
2 Press the Cursor button to move to and then press the ENTER button.
3 Press the Cursor button to move to and then press the
ENTER button.
The test tone will be sent to L ➝ C ➝ R ➝ SR ➝ SL ➝ SW in order.
If the ENTER button is pressed again at this time, the test tone will stop.
Press the RETURN button to return to the previous level.
Press the MENU button to exit the setup screen.
Setting the Test Tone
MOVE ENTER EXIT RETURN
MOVE ENTER EXIT RETURN
MOVE ENTER EXIT RETURN
ENTER EXIT