Connecting the video out to your tv, Con’t), Resetting the wireless receiving module – Samsung HT-TXQ120T-XAA User Manual

Page 10

ENG

CONNECTIONS

Choose one of the three methods for connecting to a TV.

Connecting the Video Out to your TV

Connect the supplied Video cable from the VIDEO OUT jack on the back of the subwoofer to the VIDEO IN jack on your
TV.

METHOD 3 : Composite Video ....... (Good Quality)

If your television is equipped with Component Video inputs, connect a Component video cable(not supplied) from the
Component Video Output (PR, PB and Y) jacks on the back of the subwoofer to the Component Video Input jacks on
your TV.

METHOD 2 : Component ....... (Better Quality)

•

This product only operates in 480i for Component Output.

•

After making the video connection, set the Video input source on your TV to match the corresponding
Video output (HDMI, Component or Composite) on your Home theater.
See your TV owner's manual for more information on how to select the TV's Video Input source.

METHOD2

(supplied)

METHOD 3

METHOD 1

Connect the supplied HDMI cable from the HDMI OUT jack on the back of the Main Unit to the HDMI IN jack on your TV.

METHOD 1 : HDMI ....... (Best Quality)

Rear of

Subwoofer

Rear of
Main unit

Resetting the Wireless Receiving Module

Reset the system if a communication failure occurs, or if the Link indicator (blue LED) on the wireless receiver does not
light up and the "REAR CHK" message blinks on the main unit's display.
Reset the system while the main unit and the wireless receiver module (SWA-3000) are in Power Standby mode.

With the main unit turned off, press and hold the remote

control's REMAIN button for 5 seconds.

■

The STANDBY LED on the front panel of the wireless receiver module

blinks.

With the wireless receiver module turned on, use a ball point

pen or a toothpick to press the RESET button on the back of
the unit.

■

The STANDBY LED on the front panel of the wireless receiver module

blinks 2 Times.

Turn on the main unit.

■

The LINK LED of the wireless receiver module is lit and the Reset is

completed.

■

If Power Standby mode continues, repeat Steps 1 to 3 above.

• Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close

to the main unit, some sound interruption may be heard due to interference.

• If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment, or any other device that

uses the same frequency (2.4GHz) near the system, some sound interruption may be heard due to interference.

• The transmission distance of a radio wave is about 33 feet, but may vary depending on your operating environ-

ment. If a steel-concrete wall or metallic wall is between the main unit and the wireless receiver module, the sys-
tem may not operate at all, because the radio wave cannot penetrate metal.

• When the wireless receiving module setting is complete, no sound is output from the Rear Speaker Output

Connectors on the back of the subwoofer.

• The wireless receiving antenna is built into the wireless receiver module. Keep the unit away from water and

moisture.

• For optimal listening performance, make sure that the area around the wireless receiver module location is clear of

any obstructions.

• Sound will be heard from the wireless rear speakers in DVD 5.1-CH or Dolby Pro Logic II mode only.
• In 2-CH mode, no sound will be heard from the wireless rear speakers.

Connecting the Optional Wireless Receiving Amplifier

(Con’t)