Samsung WB09H7300GP-A1 - Manual (Page 2)

ALIGNMENT AND ADJUSTMENTS
English - 2
GENERAL ERROR FUNCTION
NO
Error Code
(Diagnostic Code
Error Image)
Description Corrective Action
1 LE
A water level lower than the Reset
water level is detected for 5 seconds
during the Wash/Rinse cycle.
Go to “No Water Fill” Troubleshooting
Section.
2 1E
Water Level Sensor Trouble. (When
the input signal from the water level
sensor is out of range, the unit will
send out beeping sounds and halts
the cycle.)
Go to “No Water Fill”
Troubleshooting Section.
3 OE
A fault is detected in the water level
sensor. Data (frequency) shows
the water level is at or above the
overflow water level. (When this
condition is detected, the machine
will automatically start draining
water until the water level falls
below the reset water level)
First check to see that all of water
valves are not stuck. If the water
valves are OK, check the water level.
4 TE1
This occurs when the water
temperature sensor fault is detected
continuously for 5 seconds.
Go to ‘Board Input Test’ and check
the water temperature. Check for
loose or pinched wires. Replace the
PCB or the thermistor.
5 HE
Heater Relay Failure (No Heater
Relay Check Signal)
Replace the PCB.
6 8E
If the output from the MEMS sensor
is over 4.5V or under 0.5V and it
continues for 5 seconds, this error
occurs.
1. Check the MEMS sensor and the
PBA.
2. Check the wire connector
terminals.
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.
WARNING
F100_Technical Manual-03435A_EN_140321.indd 2 2014-03-21 �� 5:08:40