Samsung DV5451AGW-XAA - Manual (Page 21)

installing your dryer _21
Method2 - Using the Short Hose, Long Hose, and Y Connector
The dryer must be connected to the cold water faucet using the new inlet hoses. Do not use old
hoses.
If the “Y” connector cannot be attached directly to the cold water faucet, then you must use the
short hose.
1. Turn off the cold water faucet.
2. If you have a washer water hose attached to the cold water
faucet, unscrew and remove the hose.
3. Attach the short inlet hose to the cold water faucet. Screw
on the coupling by hand until it is tight.
4. Using pliers, tighten the coupling with an additional two
thirds turn.
Do not overtighten. You can damage the coupling.
5. Attach the ‘Y” connector to the stainless male end of the
small hose. Screw on the coupling by hand until it is tight.
6. Using pliers, tighten the coupling with an additional two
thirds turn.
Do not overtighten. You can damage the coupling.
7. Attach the angled end of the long hose to the fill valve at the
bottom of the dryer rear frame. Screw on the coupling by
hand until it is tight.
8. Using pliers, tighten the coupling with an additional two
thirds turn.
Do not overtighten. You can damage the coupling.
9. Turn the water faucet on.
10. Check for leaks around “Y” connector, faucets, and hoses.
01 installing your dryer
Short hose
(Inlet to cold
water)
“Y’ connector
Long hose
DV5471AE-03022A-06_EN.indd Sec3:21 DV5471AE-03022A-06_EN.indd Sec3:21 2012-10-11 5:59:20 2012-10-11 5:59:20