Asus MYPAL A636 - Manual (Page 14)

1-8 Chapter 1
Connecting to a power source
IMPORTANT You need to charge the battery before using the device for
the first time.
To connect the power adapter and charge the battery
1. Connect the power cable to the jack on the sync cable adapter.
2. Connect the 26-pin device plug of the sync cable to the 26-pin
connector at the bottom of the device.
3. Connect the power plug to a grounded wall socket.
NOTE As soon as the power cable is connected to a power source,
the battery will start charging and the power LED will show a
steady red light. See page 2-25 on how to display the battery
power status.
2
1
3
AC adapter/ Power cable
26-pin device plug
Sync cable adapter
USB sync cable