ARRI LOCPRO 35 - Manual (Page 58)

58
Fault Cause Remedy
Scratches in film perforation area Emulsion buildup on film guiding parts. Clean film guiding parts
in accordance with maintenance instructions.
Film guide runners damaged, surface worn through. Call ARRI Service station.
Pressure pad damaged Call ARRI Service station.
by stapled film
Scratches on film backing side Emulsion deposits on pressure pad or on film gate Clean pressure pad and film gate
Positive and negative film in accordance with maintenance instructions.
Pressure pad jamming. Call ARRI Service station.
HTI-Lamp dark after ignition HTI lamp not properly installed Check HTI Lamp plug for correct locking
(experienced personnel only)
Defective lamp Replace lamp (experienced personnel only)
Ballast not functioning Call service engineer
T
rouble-Shooting