Samsung RZ80EEIS - Manual (Page 11)

setting up _11 setting up _11
01 SETTING
UP
GETTING READY TO INSTALL
THE FREEZER
Congratulations on your purchase of this Samsung
Freezer. We hope you enjoy the state-of-art features
and effi ciencies that this new appliance offers.
• This freezer must be properly installed and located
in accordance with the manual before it is used.
• Use this appliance only for its intended purpose as
described in this instruction manual.
• We strongly recommend that any servicing be
performed by a qualified individual.
• Please dispose of the packaging material for this
product in an environmentally friendly manner.
Pull the power plug out of the socket before
changing the interior light of the freezer.
- Otherwise, there is a risk of electric shock.
Selecting the best location for the
Freezer
• A location without direct exposure to sunlight.
• A location with flat floor surface.
• A location with enough space for the freezer door
to open easily.
• Allow sufficient space to the right, left, back and
top for air circulation. If the freezer does not have
enough space, the internal cooling system may
perform more.
• Please ensure that appliance can be moved freely
in the event of maintenance & service.
• Height of the product may be different
depending on the models.
• Allow clearance to the right, left, back and top
when installing. This will help reduce power
consumption and keep your energy bills lower.
• Do not install the freezer in a place with the
temperature lower than 10°C.
Pull the unit straight out when installing, servicing
or cleaning behind the freezer and push it
straight back after work is complete. Make sure
your fl oor can support fully loaded freezer.
REVERSING THE FREEZER DOOR
Samsung recommends that reversing of the
door opening is only completed by Samsung
approved Service providers. This will be on
a chargeable basis and at the customers
expense.
Any damage caused while attempting to
reverse the door opening is not covered
under the appliance manufactures warranty.
Any repairs requested due to this
circumstance will be completed on a
chargeable basis at the customers expense.
Required Tools (Not provided)
Phillips Head
Driver (+)
Flat Head
Driver (-)
10mm
Socket Wrench
(for bolts)
8mm
Socket Wrench
(for bolts)
Spanner
(for hinge shaft)
4mm Hex
Wrench
(for bottom
hinge shaft)
1. Remove 2 screws on the top of the freezer.
setting up your freezer
WARNING
NN
NN
NN
PS
NN
CAUTION
WARNING
Screws Screws