Campbell Scientific TX320 Transmitter - Manual (Page 19)

TX320 Transmitter
5. Mount the TX320, CH100 or CH200 regulator, BP12 or BP24 battery
pack, and CR1000 to the backplate of an ENC16/18 enclosure.
6. Mount the enclosure and solar panel to the pole or tripod.
7. Connect the COAXNTN cable to the Yagi antenna. Then route the
COAXNTN cable through the enclosure conduit and connect it to the
TX320 connector labeled RF Out (see FIGURE 4-7 and FIGURE 4-8).
8. Connect the TNC connector of the 18017-L cable to the GPS antenna.
Route the 18017-L cable through the enclosure conduit and connect it to
the TX320 connector labeled GPS (see FIGURE 4-7 and FIGURE 4-8).
9. Wire the TX320, CH100 or CH200 regulator, BP12 battery, and CR1000
according to FIGURE 4-8 and FIGURE 4-9.
10. Route the solar panel cable through the enclosure conduit and connect the
red and black wires to the CHG terminals on the CH100 or CH200.
Connector for
GPS antenna
Connector for
Yagi antenna
FIGURE 4-7. Antenna connectors
9