Campbell Scientific RDP500 Remote Data Platform - Manual (Page 6)

RDP500 Remote Data Platform
(1) RDP500 ENCLOSURE MOUNTING BRACKET [p/n 21921]
(1) RDP500 ENCLOSURE BACK PANEL [p/n 21922]
(2) NUT ¼”-20 [p/n1132]
(4) HRD SCREW 5/16-18 X .750 CAP HEX SS [p/n 4364]
(4) HRD SCREW #10-32 X .375 PAN PHILLIPS [p/n 6950]
(4) HRD WASHER 5/16 FLAT [p/n 4365]
(1) HRD CABLE ENTRY SEAL .110 - .260 ID PG7 W/NUT [p/n 8913]
(2) HRD CABLE ENTRY SEAL .187 - .312 ID [p/n 5771]
(1) FAB ENC HEYCO CONNECTOR PLUG .250 DIA [p/n 6688]
(1) FAB ENC CASE GROUND LUG SINGLE CONNECTOR [p/n 5449]
(1) HRD CABLE ENTRY SEAL .187 - .312 ID NPT [p/n 14286]
(1) HRD FITTING PIPE HEX REDUCING BUSHING, 1/2 MNPT X 3/8
FNPT [p/n 21923]
(2) HRD NUT #10-32 [p/n 23]
(1) GROUND CABLE [p/n 5725]
SUB ENCLOSURE GROUND CONNECTION
2.1.1 Common Accessories
The CR1000KD is ordered as an accessory. This unit allows technicians to
perform installation and calibration functions, but may not be useful to onsite
personnel.
3. Installation
3.1 Rain Gauge Preparation
1. Remove the upper hood of the rain gauge, empty and dry the bucket.
2. Lift off the lower housing and disconnect the internal wiring along with
any clamps and terminal strips.
3. Unscrew the two screws holding the pointer from the front arm of the
parallelogram (Figure 3.1-1).
2