Campbell Scientific RAWS-P Remote Automated Weather Station - Manual (Page 29)

RAWS-P Remote Automated Weather Station
performance testing (for example, bearing torque), and sensor component
replacement, generally requires sending the instrument to Campbell Scientific.
A station log should be maintained for each weather station that includes
equipment model and serial numbers and maintenance that was performed.
Consult the equipment manual for routine maintenance
procedures. NOTE
Contact Campbell Scientific, phone (435) 227-9000, for an RMA
number before returning sensor or equipment for service. NOTE
8. References
General guidelines for site selection are listed below.
EPA, (1987): On-Site Meteorological Program Guidance for Regulatory
Modeling Applications, EPA-450/4-87-013, Office of Air Quality
Planning and Standards, Research Triangle Park, NC, 27711.
WMO, (1983): Guide to Meteorological Instruments and Methods of
Observation, World Meteorological Organization, No. 8, 5th edition,
Geneva, Switzerland.
The State Climatologist, (1985): Publication of the American Association of
State Climatologists: Height and Exposure Standards, for Sensors on
Automated Weather Stations, vol. 9, No. 4.
EPA, (1989): Quality Assurance Handbook for Air Pollution Measurement
Systems, EPA Office of Research and Development, Research Triangle
Park, North Carolina 27711.
9. RAWS Orientation
9.1 Determining True North and Sensor Orientation
Orientation of the wind direction sensor is done after the datalogger has been
programmed and the location of True North has been determined. True North
is usually found by reading a magnetic compass and applying the site-specific
correction for magnetic declination; where the magnetic declination is the
number of degrees between True North and Magnetic North. Magnetic
declination for a specific site can be obtained from a USGS map, local airport,
or through the web calculator offered by the USGS (Section 9.2, USGS Web
Calculator). A general map showing magnetic declination for the contiguous
United States is shown in FIGURE 9-1.
Declination angles are always subtracted from the compass reading to find
True North. A declination angle east of True North is reported as positive a
value and is subtracted from 360 (0) degrees to find True North as shown
FIGURE 9-2. A declination angle west of True North is reported as a negative
value and is also subtracted from 0 (360) degrees to find True North as shown
21