Campbell Scientific CC640 Digital Camera - Manual (Page 45)

CC640 Digital Camera
15.3 Enclosure Mounting Kit
The 18549 Enclosure Mounting Kit is used to mount the 18543 camera
enclosure to a CM202, CM204, or CM206 crossarm. The crossarm then
attaches to a tripod, tower, or user-supplied pole (1.0” to 2.1” outer diameter).
Figure 20 shows the camera enclosure mounted to a crossarm via this bracket.
The enclosure fastens to the bracket via two #5226 screws (1/4-20 x .5 cap hex
grade 5) and two #5428 washers (1/4 flat SS). A u-bolt connects the bracket to
a crossarm. Curved notches in the bracket allow you to aim the camera at the
desired target.
Camera
Enclosure
Bottom
Crossarm
Cable Port
Cable Port
Curved Notch
U-bolt
Curved Notch
#5226 Screw
#5226 Screw
FIGURE 20. Camera Mount to Crossarm
39