Campbell Scientific 109SS Temperature Probe - Manual (Page 12)

Model 109SS Temperature Probe
Stainless-Steel Sheath
Diameter: 0.16 cm (0.063 in)
Length: 5.84 cm (2.3 in)
Overmolded Joint
Diameter: 1.02 cm (0.40 in)
Length: 4.24 cm (1.67 in)
Cable: Santoprene ® , 0.220 in diameter
Cable/Probe Connection: ATUM TM heat shrink
Macromelt ® overmolded joint
Weight: 0.2 lb per 10.5 ft cable
7. Installation
If you are programming your datalogger with Short Cut, skip Section 7.1,
Wiring to Datalogger, and Section 7.2, Datalogger Programming. Short Cut
does this work for you. See Section 4, Quickstart, for a Short Cut tutorial.
7.1 Wiring to Datalogger
TABLE 7-1. Wire Color, Function, and Datalogger Connection
Wire Color Wire Function
Datalogger Connection
Terminal
Black Voltage-excitation input
EX, VX
(voltage excitation)
Red Analog-voltage output
SE
(single-ended,
analog-voltage input)
Purple Bridge-resistor lead
AG or
(analog ground)
Clear EMF shield
G
(power ground)
7.2 Datalogger Programming
Short Cut is the best source for up-to-date datalogger programming code.
Programming code is needed when:
• Creating a program for a new datalogger installation.
• Adding sensors to an existing datalogger program.
If your data acquisition requirements are simple, you can probably create and
maintain a datalogger program exclusively with Short Cut. If your data
acquisition needs are more complex, the files that Short Cut creates are a great
source for programming code to start a new program or add to an existing
custom program.
6