beautypg.com

LBL Lighting MO Surf Elec Xfmr 100w 277v/12v LED User Manual

Single flexible feed recessed transformer

background image

Installation Instructions for

Single Flexible Feed Recessed Transformer

980MRLSFERRT

1

1.2

TRANS-RRE_

G

P

I

ENERAL

RODUCT NFORMATION

This product is suitable only for dry locations and approved for use

at any height above the finished floor.
This product must

be installed in insulated ceilings.

not

This product may be dimmed only with a low voltage electronic

dimmer. Using a dimmer not designed for low voltage electronic

applications may work initially, but could eventually cause

transformer failure and will void the warranty. The dimmer must be

derated as indicated by the dimmer manufacturer.

This product is intended for use with LBL Lighting low voltage

lighting systems only.

A typical installation is shown. Specific installation must be in

accordance with local electrical codes. Read all instructions

thoroughly before installing.

IMPORTANT SAFETY INFORMATION

Do not conceal or extend bus bar conductors through a building
wall.

To reduce the risk of fire and burns, do not install this lighting
system where the uninsulated open bus bar conductors can be
shorted or contact any conductive materials.

To reduce the risk of the system overheating and possibly causing a
fire, make sure all the connections are tight.

Do not install fixture assemblies closer than six inches to curtains
or similarly combustible materials.

Turn the electrical power off before modifying the lighting system in
any way.

The fixtures used with the system must be identified to be used
with the corresponding system.

Minimum volume of the electrical box must be 6 cubic inches (98
cubic centimeters).

Load the circuit of the transformer to no more than the maximum
rated capacity as specified.

To reset the electronic surface transformer, turn the power off then
on (main power, breaker panel, or wall switch).

Monorail

CAUTION - RISK OF FIRE

This product requires installation by a qualified
electrician. Before installing be sure to read all
instructions and TURN THE POWER TO THE
ELECTRICAL BOX OFF.