Allied Telesis 86241-06 - Manual (Page 8)

8 Patch Release Note
Patch 86241-05 for Software Release 2.4.1
C613-10340-00 REV E
PIM was disabled permanently if the RESET IP command, or the DISABLE
IP command followed by the ENABLE IP commands were executed. PIM is
now automatically restarted if these commands are used.
Previously the SET FIREWALL POLICY RULE command permitted the use
of the GBLIP and GBLPORT parameters in ways that were not permitted by
the ADD FIREWALL POLICY RULE command. This caused problems
when a configuration file was generated because some of the illegal
parameters from the SET command were put into the ADD command. This
resulted in a configuration that contained illegal parameter combinations.
The restrictions placed on the GBLIP and GBLPORT parameters in the ADD
command have now been implemented in the SET command so that these
problems do not occur.
IP ARP packets that had invalid header values were erroneously accepted
by the router. Also, IP packets with a Class E source IP address were
erroneously fowarded. These issues have been resolved.
When the system time was set to a time that was before or significantly after
the current time, Firewall sessions were prematurely deleted. This issue has
been resolved.
If a problem occurred with NVS, some critical files were lost. As a result, the
equipment was forced to load only boot ROM software at boot time. This
patch combined with the new version of the boot ROM software (pr1-1.2.0
for the AR700 series) resolves this issue.
The ARP cache is now updated when a gratuitous ARP request or reply
packet is received.
The ADD IP ROUTE FILTER optional parameter INTERFACE caused the
filter to not work on the OSPF external LSA’s flooding.
The SHOW IP ROUTE FILTER interface name output was truncated to 6
characters. These issues have been resolved.
Executing the PING command sometimes caused a memory leak. This issue
has been resolved.
The CREATE CONFIGURATION command inserted the IMTLEAVE
parameter into the configuration script when the IMTLEAVE parameter
was undefined. This caused an error in the configuration script. This issue
has been resolved.
PCR: 02340 Module: IPG Network affecting: No
PCR: 02356 Module: FIREWALL Network affecting: No
PCR: 02358 Module: IPG Network affecting: No
PCR: 02371 Module: FIREWALL Network affecting: No
PCR: 02400 Module:
CORE,FFS,FILE,INSTALL,SCR Network affecting: No
PCR: 02491 Module: IPG Network affecting: No
PCR: 02506 Module: OSPF IPG Network affecting: No
PCR: 02511 Module: Ping Network affecting: No
PCR: 02514 Module: IPG Network affecting: No