Allied Telesis 86241-06 - Manual (Page 4)

4 Patch Release Note
Patch 86241-05 for Software Release 2.4.1
C613-10340-00 REV E
DHCP was assigning incorrect IP addresses to clients when they moved
from a relayed to a non-relayed range. Gateway checks have been added to
remove this issue.
Deriving the originating VLAN from incoming packets could, in some
circumstances, cause a software restart. This issue has been resolved.
The PING command when executed with the LENGTH and PATTERN
parameters could produce an ICMP echo packet with an incorrect ICMP
checksum. This issue has been resolved.
When an IP packet with an invalid TOTAL LENGTH field was received by
the CPU routing process, subsequent valid packets were dropped. This
issue has been resolved.
The mechanism for freeing discarded packets in Frame Relay and PPP
could, in some circumstances, cause a software restart. This issue has been
resolved.
The DISABLE MLDS command appeared twice in configuration files. This
issue has been resolved.
The ADD IP MVR command could cause a software restart. This issue has
been resolved.
The ADD IP MVR command parameter GROUP now only accepts multicast
addresses.
With DVMRP configured, the switch did not forward multicast data to
downstream interfaces on the same VLAN. This issue has been resolved.
DHCP clients that shifted between relayed ranges were not always
recognised, and were occasionally allocated incorrect addresses. This issue
has been resolved.
Invalid DVMRP prune messages could cause a software restart. This issue
has been resolved.
Adding a static ARP entry to a trunk group could cause a software restart.
This issue has been resolved.
PCR: 03100 Module: DHCP Level:
PCR: 03101 Module: IPG Level: 2
PCR: 03102 Module: IPG Level: 3
PCR: 03104 Module: IPG Level: 3
PCR: 03107 Module: FR, PPP Level: 2
PCR: 03108 Module: MLDS Level: 4
PCR: 03110 Module: IPG Level: 2
PCR: 03113 Module: DVMRP Level: 2
PCR: 03114 Module: DHCP Level: 3
PCR: 03121 Module: DVMRP Level: 2
PCR: 03122 Module: SWI Level: 2