Allied Telesis 86241-06 - Manual (Page 6)

6 Patch Release Note
Patch 86241-05 for Software Release 2.4.1
C613-10340-00 REV E
Features in 86241-05
Patch file details are listed in Table 2:
Patch 86241-05 includes all issues resolved and enhancements released in
previous patches for Software Release 2.4.1, and the following enhancements:
Support has been added for SNMPv2c.
SNMP responses will be sent in the same version format as the request
message. Minimal configuration is required to specify a SNMP format,
because this is decided on a message by message basis. The only thing you
need to specify is the version of SNMP received by trap hosts.
To create an SNMP community, use the command:
CREATE SNMP COMMUNITY=name [ACCESS={READ|WRITE}]
[TRAPHOST=ipadd] [MANAGER=ipadd]
[OPEN={ON|OFF|YES|NO|TRUE|FALSE}] [V1TRAPHOST=ipadd]
[V2CTRAPHOST=ipadd]
To add a trap host or management station to the previously created SNMP
community, use the command:
ADD SNMP COMMUNITY=name [TRAPHOST=ipadd] [MANAGER=ipadd]
[V1TRAPHOST=ipadd] [V2CTRAPHOST=ipadd]
DS3 interface and board type support has been added. DS3 is now
supported over PPP and Frame Relay. DS3 MIB support has been added.
For more information on DS3, see “DS3 Interfaces” on page 22 of this release
note.
This patch resolves issues that arose after previous modifications made
under this PCR number.
Sometimes IPv6 features did not enable correctly. Also, there were some
errors in the output from configuration commands. These issues have been
resolved.
IP packet throughput has been improved.
Table 2: Patch file details for Patch 86241-05.
Base Software Release File 86s-241.rez
Patch Release Date 17-Jan-2003
Compressed Patch File Name 86241-05.paz
Compressed Patch File Size 332388 bytes
PCR: 02315 Module: SNMP Network affecting: No
PCR: 02389 Module: DS3 Network affecting: No
PCR: 02414 Module: IPv6, SWI, IPG, VLAN Network affecting: No
PCR: 02560 Module: IPG, SWI, VLAN Network affecting: No