LBL Lighting 2-Circuit MO Surf Mag Xfmr 500w 120v/12v - Manual (Page 4)

Hook the transformer safety wire onto the backplate bracket.
Connect the backplate to a suitable ground in accordance with
local electrical codes.
For each set of power line wires, connect the hot and neutral
wires to the black and white transformer wires, respectively.
SAFETY WIRE
BACKPLATE
BRACKET
4
Line up the notch on the middle contact with the M3 set
screw on the plastic cylinder and insert the middle contact
into the plastic cylinder.
Screw the knurled cap to the plastic cylinder slightly so that
the middle contact is secured in place and not exposed in the
power housing.
MIDDLE
CONTACT
KNURLED CAP
PLASTIC
CYLINDER
Connect the 2-Circuit Monorail to
the Transformer
Connect the 2-Circuit Monorail to the standoffs so that the
2-Circuit Monorail is secured in place. Refer to the instructions
provided with the standoff.
Make sure that the transformer power is off.
Place the power feed housing onto the 2-Circuit Monorail.
Completely back out the screw on the power feed cap.
Screw the power feed cap completely to the power feed
housing. Make sure that the power feed cap is not cross
threaded.
Tighten the screw on the power feed cap for proper power
connection.
2-CIRCUIT
MONORAIL
SCREW
POWER
FEED CAP
Tighten the knurled cap completely to plastic cylinder for a
proper power connection.
Tighten the M3 set screw on plastic cylinder with the 1.5MM
Allen wrench.
M3 SET SCREW
1.5MM ALLEN
WRENCH
KNURLED CAP
Slide the vertical portion of the housing "L" slots completely
onto the three backplate #8-32 flat head screws.
Rotate the transformer housing clockwise to lock the housing
slots around the #8-32 flat head screws.
Tighten the three #8-32 flat head screws with the 3/32 Allen
wrench to secure the transformer in place.
#8-32 FLAT
HEAD SCREW
HOUSING
NOTE: All transformer power line wires must be
connected to the same phase.
SAVE THESE INSTRUCTIONS!
7400 Linder Ave, Skokie, IL 60077
800.323.3226 - 847.626.6300
www.lbllighting.com
© 2014 LBL Lighting.All rights reserved.The "LBL Lighting" graphic is a
registered trademark of LBL Lighting. LBL Lighting reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company A Generation Brands Company
1A 2C
1A 2D
1A 2E
5
6
7
11
8
9
10
12
1A 3A
1A 3B
5
6
7
8
2
3
4
1
12
10
5
7
3
7
6
8
9
11
5
4
5
6
7
8