Adjust the power feed height, 1a 1b – LBL Lighting 2-Circuit MO Surf Mag Xfmr 500w 120v/12v User Manual
Page 2
33"
36"
METAL TUBE
2
Adjust the Power Feed Height
Loosen
the two M3 set screws on power
(Do Not Remove)
feed housing and one M3 set screw on plastic cylinder with the
provided 1.5MM Allen wrench.
Remove the power feed cap from the power feed housing.
Loosen the knurled cap from the plastic cylinder and remove
the middle contact.
POWER FEED CAP
POWER FEED
HOUSING
1.5 MM ALLEN
WRENCH
M3 SET SCREW
PLASTIC
CYLINDER
KNURLED CAP
MIDDLE CONTACT
Slide the power feed housing down to expose the metal tube.
Open the metal tube slot to unwrap and remove it from the
cord. Discard the metal tube.
POWER FEED HOUSING
CONTACT POST
INSULATED BUSHING
M3 SET SCREW
1.5MM ALLEN WRENCH
M3 SET SCREW
MIDDLE CONTACT
Slide the insulated bushing down to expose the contact post.
Loosen
the M3 set screw on the contact
(Do Not Remove)
with the 1.5MM Allen wrench.
Remove the contact post, insulated bushing, and power feed
housing.
Loosen
the two M3 set screws on the
(Do Not Remove)
middle contact with the 1.5MM Allen wrench and remove the
middle contact from the center wire.
POWER FEED
HOUSING
Determine the transformer height (H).Always add 2" to the
desired height so that there is no tension on the cord when it
is installed. For example, if the desired transformer height (H)
is 12", then cut the power feed cord 24.5" (38.5" -14" = 24.5")
shorter.
With a sharp cutter, cut the power feed cord and the center
wire to the desired length.
The overall length of the transformer (from top of the
transformer to bottom of the power feed connector) is 40".
The transformer height (H) is measured from top of the
transformer to top of the 2-Circuit Monorail (when it is
installed) which is about 38.5" when the power feed height is
not adjusted.
the power feed cord more than
DO NOT CUT
30".The minimum transformer height (H) is 9".
NOTE:
It is recommended to adjust the power feed
height before installing the transformer.
4"
H
1A
1A
1A
1B
1
2
1
2
3
4
4
2
3
6
5
7
8
9
10
11
12
1A
1C
1A
1D
1A
1E
7
8
10
6
5
12