LBL Lighting 2-Circuit MO Direct Feed Canopy Dual Feed - Manual (Page 2)

2
Place all wires and wire nut connections inside the electrical
box.
Tighten the two provided #8-32 flat head screws to the
electrical box holes with the 3/32 Allen wrench to secure the
canopy in place.
#8-32 FLAT
HEAD SCREW
3/32 ALLEN WRENCH
Install the 2-Circuit Monorail to the
Power Feed Canopy
Push two 2-Circuit Monorail sections completely onto the
straight isolating connectors.
Tighten the M3 set screws firmly with the provided 1.5 MM
Allen wrench. the set screws which Do Not Over Tighten
may strip the thread.
M3 SET SCREW
1.5 MM ALLEN
WRENCH
STRAIGHT ISOLATING CONNECTOR
2-CIRCUIT MONORAIL 2-CIRCUIT MONORAIL
NOTE: The standoffs should be installed to support the
2-Circuit Monorail while connecting 2-Circuit Monorail to
the power feed canopies. Refer to the instructions
provided with the standoffs.
Remove the power feed cap from the power feed housings.
Completely back out the screw on the power feed caps.
Loosen the knurled cap on both power (Do Not Remove)
feed housings and pull the middle contact wire slightly out so
that the middle contact is not exposed in both power feed
housings.
POWER FEED CAP
SCREW
POWER FEED
HOUSING
KNURLED CAP
MIDDLE
CONTACT
MIDDLE
CONTACT WIRE
1B
8
1B
7
8
8
3
1
4
3
1A 2A
1A 2B
2
5
2
1 1
3
5
4
5
5