LBL Lighting 2-Circuit MO Direct Feed Canopy Dual Feed - Manual

Installation Instructions for 980MR24RDDPFC
1
4" Round Dual-Post Power Feed Canopy 1.0 REMOTECNPYDIRDF_-2C
G P I : ENERAL RODUCT NFORMATION
This product is suitable for indoor dry locations only.
Minimum volume of the electrical box must be 6 cubic inches (98
cubic centimeter).
Install the Power Feed Canopy
NOTE: The low voltage wires should be present in the
electrical box prior to these steps. Refer to the instructions
provided with the remote transformer to install the remote
transformer and low voltage wires.
Starting with the left post, connect the power feed wire
coming out of the middle contact (the wire coming out of the
knurled cap) to the low voltage wire marked "HOT B1" with a
wire nut.
Connect the center power feed wire (that is attached to the
top contact) to the low voltage wire marked "HOT A1" with a
wire nut.
Connect the remaining side wire to the low voltage wire
marked "COM 1" with a wire nut.
Continue with right post and connect the power feed wire
coming out of the middle contact (the wire coming out of the
knurled cap) to the low voltage wire marked "HOT B2" with a
wire nut.
Connect the center power feed wire (that is attached to the
top contact) to the low voltage wire marked "HOT A2" with a
wire nut.
Connect the remaining side wire to the low voltage wire
marked "COM 2" with a wire nut.
NOTE: Use the provided universal round crossbar when
the canopy holes do not line up with the electrical box
holes.
HOT B1
HOT A1
COM 1 COM 2
HOT A2
HOT B2
WIRE COMING
FROM MIDDLE
CONTACT WIRE COMING
FROM MIDDLE
CONTACT
TOP CONTACT TOP CONTACT
CENTER
WIRE
CENTER
WIRE
1A 1
2
3
4
6
5
1A
1
2
3 6
4
5
2-Circuit Monorail