LBL Lighting Top II W - Manual (Page 2)

1E
1F
2
Connect the transformer white wire to the neutral power line
wire with a wire nut.
Connect the transformer black wire to the hot power line
wire with a wire nut.
Place the transformer inside the electrical box. Use the
attached sticky pad to secure it against the electrical box.
STICKY PAD
Line up two backplate holes with the electrical box holes.
Mount the backplate to the electrical box with the two #8-32
screws provided.
In accordance with local electrical codes, make sure that the
backplate and the transformer green wire are grounded.
BACKPLATE
ELECTRICAL BOX HOLE
#8-32 SCREW
Connect each transformer low voltage wire (red wire) to one
fixture wire with a wire nut.
Place all wires and wire nut connections inside the electrical
box.
CANOPY
1.5MM ALLEN WRENCH
M3 SET SCREW
Place the fixture canopy onto the backplate. Level the fixture
vertically and tighten the two M3 set screws with the 1.5MM
Allen wrench to secure the fixture in place.
1C
5
6
7
5
7
6
8
1D
9
10
10
9
11
12
13
9
8
11
11
13
13